IBM HS40 - BladeCenter - 8839 Maintenance And Troubleshooting Manual page 92

Note: See Chapter 7, "Parts listing, Type 8839," on page 105 to determine which components should be replaced by
a field service technician.
Error code/symptom
84F2
(Server management interface failed)
84F3
(BMC in update mode)
84F4
(Sensor Data Record empty)
84FF
(System Event Log full)
00150900
(SERR/PERR detected on PCI bus.)
00151730
(IMB parity/CRC error)
The following errors appear on the screen during POST and in the
management-module error log.
Note: See Chapter 7, "Parts listing, Type 8839," on page 105 to determine which components should be replaced by
a field service technician.
Error code/symptom
Microprocessor 1 internal error (IERR)
Microprocessor 2 internal error (IERR)
Microprocessor 3 internal error (IERR)
Microprocessor 4 internal error (IERR)
82
BladeCenter HS40 Type 8839: Hardware Maintenance Manual and Troubleshooting Guide
FRU/action
1. Update the BMC and SDRs with the most current versions that
are compatible with your system configuration.
2. I/O board.
1. The BMC recovery jumper is in the active position and the BMC
can be updated.
2. After updating the BMC, move the jumper to the inactive position.
1. Update the BMC and SDRs with the most current versions that
are compatible with your system configuration.
2. I/O board.
3. Processor board.
Clear the System Event Log.
1. PCI-X adapter
2. I/O board
1. DIMM
2. Processor board
FRU/action
1. Run the Configuration/Setup Utility program, and enable the
microprocessor retest.
2. Microprocessor 1.
3. Processor board.
1. Run the Configuration/Setup Utility program, and enable the
microprocessor retest.
2. Microprocessor 2.
3. Processor board.
1. Run the Configuration/Setup Utility program, and enable the
microprocessor retest.
2. Microprocessor 3.
3. Processor board.
1. Run the Configuration/Setup Utility program, and enable the
microprocessor retest.
2. Microprocessor 4.
3. Processor board.