Removing The Blade Server Bezel Assembly - IBM LS20 - BladeCenter - 8850 Installation And User Manual

CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade cover before installing the blade server.

Removing the blade server bezel assembly

To install certain options, you must first remove the blade server bezel assembly.
The following illustration shows how to remove the bezel assembly.
To remove the blade server bezel assembly, complete the following steps:
1. Read the safety information beginning on page v and "Installation guidelines" on
2. Open the blade server cover (see "Opening the blade server cover" on page 17
3. Press the bezel-assembly release on each side of the blade server and pull the
4. Disconnect the control-panel cable from the control-panel connector.
5. Pull the bezel assembly away from the blade server.
6. Store the bezel assembly in a safe place.
18
AMD Opteron LS20 Type 8850 for IBM BladeCenter: Installation and User's Guide
Bezel-assembly
release
Control-panel
connector
Control-panel
cable
page 15.
for instructions).
bezel assembly away from the blade server approximately 1.2 cm (0.5 inch).
Bezel-assembly
release
Bezel
assembly