Power-Supply Structure - IBM 8872 - eServer xSeries 460 Service Manual

9. If you are instructed to return the PCI-X adapter guide, follow all packaging
To install the replacement PCI-X adapter guide, complete the following steps:
10. Turn on all attached devices and the server.

Power-supply structure

To remove the power-supply structure, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Remove the top cover (see "Top cover and bezel" on page 113).
4. Remove the memory cards (see "Removing and replacing a memory card" on
instructions, and use any packaging materials for shipping that are supplied to
you.
1. Align the two tabs on the PCI-X adapter guide with the two slots on the
chassis.
2. Set the guide firmly into place and turn the quarter-turn fasteners to secure the
guide.
3. Reconnect the cables that pass through the PCI-X adapter guide and route the
cables through the routing feature of the guide.
4. Install the adapters and dividers.
5. When replacing the dividers, make sure that the tabs on the bottom of the
dividers rest in the holes in the bottom of the metal section of the guide and
the tabs on the top of the dividers engage the plastic retainer section of the
guide.
6. Lower the latch mechanism.
7. Install the top cover (see "Top cover and bezel" on page 113).
8. Slide the server into the rack.
9. Connect the cables and power cords (see "Completing the installation" in the
Installation Guide or User's Guide for cabling instructions).
on page 99.
all external cables necessary to replace the device.
page 108).
Latches
Alignment tabs
Chapter 4. Removing and replacing server components
Handle
Alignment pins
119