IBM 8872 - eServer xSeries 460 Service Manual page 126

7. If you are instructed to return the DIMM, follow all packaging instructions, and
To install the replacement DIMM, complete the following steps:
1. Open the retaining clip on each end of the DIMM connector.
2. Touch the static-protective package that contains the DIMM to any unpainted
3. Turn the DIMM so that the DIMM keys align correctly with the slot.
4. Insert the DIMM into the connector by aligning the edges of the DIMM with the
5. Replace the memory card (see "Removing and replacing a memory card" on
6. Install the top cover (see "Top cover and bezel" on page 113).
7. Slide the server into the rack.
110
IBM xSeries 460 Type 8872 and xSeries MXE 460 Type 8874: Problem Determination and Service Guide
DIMM
use any packaging materials for shipping that are supplied to you.
metal surface on the server. Then, remove the DIMM from the package.
DIMM
slots at the ends of the DIMM connector. Firmly press the DIMM straight down
into the connector by applying pressure on both ends of the DIMM
simultaneously. The retaining clips snap into the locked position when the DIMM
is seated in the connector. If there is a gap between the DIMM and the retaining
clips, the DIMM has not been correctly inserted; open the retaining clips,
remove the DIMM, and then reinsert it.
page 108).
Retaining
clip
Retaining
clip