8. If you disconnected any cables or power cords to replace the DIMM, connect
9. If you turned off the server to replace the DIMM, turn on all attached devices
Remote Supervisor Adapter II SlimLine
The Remote Supervisor Adapter II SlimLine must be installed in its dedicated
connector on the I/O board.
To remove the Remote Supervisor Adapter II SlimLine, complete the following
steps:
Remote Supervisor Adapter II SlimLine connector
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Remove the top cover (see "Top cover and bezel" on page 113).
4. Release the retention latch on the rear standoff and pull the adapter from the
5. If you are instructed to return the Remote Supervisor Adapter II SlimLine, follow
To install the replacement Remote Supervisor Adapter II SlimLine, complete the
following steps:
1. Insert the rear of the adapter into the rear standoff; then, rotate the front of the
2. Press the Remote Supervisor Adapter II SlimLine firmly into the connector.
3. Install the top cover (see "Top cover and bezel" on page 113).
4. Slide the server into the rack.
5. Connect the cables and power cords (see "Completing the installation" in the
6. Turn on all attached devices and the server.
the cables and power cords (see "Completing the installation" in the Installation
Guide or User's Guide for cabling instructions).
and the server.
Front standoff
on page 99.
all external cables necessary to replace the device.
I/O board.
all packaging instructions, and use any packaging materials for shipping that are
supplied to you.
adapter into the front standoff.
Installation Guide or User's Guide for cabling instructions).
Rear standoff
Remote Supervisor Adapter II SlimLine
Chapter 4. Removing and replacing server components
I/O board
111