DVD drive
To remove the DVD drive, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Remove the top cover and bezel (see "Top cover and bezel" on page 113).
4. Pull the blue retention latch forward and pull the DVD drive out of the server.
5. If you are instructed to return the DVD drive, follow all packaging instructions,
To install the replacement DVD drive, compete the following steps:
1. Slide the DVD drive into the server to engage the drive.
2. Install the top cover and bezel (see "Top cover and bezel" on page 113).
3. Slide the server into the rack.
4. Connect the cables and power cords (see "Completing the installation" in the
5. Turn on all attached devices and the server.
104
IBM xSeries 460 Type 8872 and xSeries MXE 460 Type 8874: Problem Determination and Service Guide
on page 99.
all external cables necessary to replace the device.
and use any packaging materials for shipping that are supplied to you.
Installation Guide or User's Guide for cabling instructions).
Retention latch