Power-Supply Structure - IBM 8863 - eServer xSeries 366 Service Manual

8. Lift the guide out of the server.
To install a PCI-X adapter guide, complete the following steps:
1. Align the two tabs on the PCI-X adapter guide with the two slots on the chassis.
2. Set the guide firmly into place and turn the quarter-turn fasteners to secure the
3. Reconnect the cables that pass through the PCI-X adapter guide and route the
4. Install the adapters and dividers.
5. When replacing the dividers, make sure that the tabs on the bottom of the
6. Lower the latch mechanism.
7. Replace the top cover.
8. Reconnect external cables and power cords.

Power-supply structure

To remove the power-supply structure, complete the following steps.
1. Read the safety information that begins on page vii, and "Handling
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Remove the top cover.
4. Remove the memory cards (see "Removing and replacing a memory card" on
5. Remove the power supplies (see "Hot-swap power supply" on page 106).
guide.
cables through the routing feature of the guide.
dividers rest in the holes in the bottom of the metal section of the guide and the
tabs on the top of the dividers engage the plastic retainer section of the guide.
Latches
static-sensitive devices" on page 100.
Attention: Static electricity that is released to internal server components
when the server is powered-on might cause the server to halt, which could
result in the loss of data. To avoid this potential problem, always use an
electrostatic-discharge wrist strap or other grounding system when working
inside the server with the power on.
all external cables necessary to replace the device.
page 111).
Alignment tabs
Handle
Alignment pins
Chapter 4. Removing and replacing server components
121