Remote Supervisor Adapter Ii Slimline - IBM x3950 Problem Determination And Service Manual

5. Replace the memory card (see "Removing and replacing a memory card" on
6. Install the top cover (see "Top cover and bezel" on page 131).
7. Slide the server into the rack.
8. Connect the cables and power cords (see "Connecting the cables" on page 120
9. If you turned off the server to replace the DIMM, turn on all attached devices

Remote Supervisor Adapter II SlimLine

The Remote Supervisor Adapter II SlimLine must be installed in its dedicated
connector on the I/O board.
To remove the Remote Supervisor Adapter II SlimLine, complete the following
steps:
Remote Supervisor Adapter II SlimLine connector
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Remove the top cover (see "Top cover and bezel" on page 131).
4. Release the retention latch on the rear standoff and pull the adapter from the
5. If you are instructed to return the Remote Supervisor Adapter II SlimLine, follow
To install the replacement Remote Supervisor Adapter II SlimLine, complete the
following steps:
1. Insert the rear of the adapter into the rear standoff; then, rotate the front of the
2. Press the Remote Supervisor Adapter II SlimLine firmly into the connector.
3. Install the top cover (see "Top cover and bezel" on page 131).
page 126).
for cabling instructions).
and the server.
Rear standoff
on page 117.
all external cables necessary to replace the device.
I/O board.
all packaging instructions, and use any packaging materials for shipping that are
supplied to you.
adapter into the front standoff.
Front standoff
Remote Supervisor Adapter II SlimLine
Chapter 4. Removing and replacing server components
I/O board
129