Table of Contents
Advertisement
IBM NetVista
Note: The ribbon cable connectors are keyed so that they can only
be installed correctly on the device connector. If the
connector is not keyed, make sure that you match the pin-1
side of the cable connector with the pin-1 side of the device
connector. Each connector has the pin-1 side clearly marked.
The pin-1 side of each ribbon cable is always marked with a
colored stripe on the cable.
3.
Plug an IDE cable connector into the hard disk drive IDE
connector (B). It doesn't matter which connector on the cable
you use.
4.
Plug a power cable from the case power supply into the power
connector on the hard disk drive (C).
When you first start up your system, the BIOS should automatically
detect your hard disk drive. If it doesn't, enter the Setup Utility and
use the IDE Hard Disk Auto Detect feature to configure the hard
disk drive that you have installed.
Installing a CD-ROM(RW)/DVD Drive
1.
Install the CD-ROM/DVD drive into the drive bay.
2.
Plug the IDE cable into IDE1 (A). If you have already installed
an HDD, use the other connector on the IDE cable.
Colored
stripe
HDD
B
C
A
A
Pin 1
24/53
Advertisement
Table of Contents
