Installing And Removing The Intel ® Remote Management Module; Rmm2); Rmm2 And Nic Module - Intel S7000FC4UR - Server System - 0 MB RAM Product Manual

Installing and Removing the Intel
Management Module 2 (Intel
The optional Intel
•
One Intel
•
One network interface card (NIC) module
•
One plastic bag of screws, a slot bracket, cabling, and three plastic standoffs (these
standoffs are not used for this installation)
Installing the Intel
1. Remove the top cover. For instructions, see
2. Remove the I/O riser card. For instructions, see
page
3. Set the I/O riser card on a static-controlled surface with the components facing up.
4. Write down the MAC address on the Intel
Intel
Intel
before you can configure the Intel
Note: The I/O gasket is required to meet EMI requirements.
5. Peel the backing from the EMI gasket that is included with your Intel
Management Module 2 kit. See letter "A" in the following figure.
6. Adhere the EMI gasket to the I/O riser board where the NIC will contact the I/O
riser. See letter "B" in the figure.
Intel® Server System S7000FC4UR Product Guide
®
RMM2 comes as a kit with these contents:
®
Remote Management Module 2 with one plastic standoff pre-installed
®

RMM2 and NIC Module

118.
®
RMM2. If you do not write down the MAC address before installing the
®
RMM2, you will need to open the system later to record this information
®
Remote
®

RMM2)

"Removing the Top Cover" on page
"Removing the I/O Riser Board" on
®
RMM2. It is on a label attached to the
®
RMM2.
90.
®
Remote
119