DAELIM S2-250 Service Manual page 96

MOVABLE GUIDE GROOVE
DRIVEN FACE
DRIVEN FACE
LH. CRANKCASE COVER/CONTINUOUSLY VARIABLE TRANSMISSION
● Check the driven face assembly for wear or damage.
● Measure the driven face O.D.
● Check the movable driven face for wear or damage.
● Measure the movable driven face I.D.
DRIVEN PULLEY FACE BEARING
REPLACEMENT
● Remove the inner needle bearing out of the driven
● Remove the snap ring and drive the outer bearing out
● Apply grease to the outer bearing.
● Install a new outer bearing into the driven face with the
● Seat the snap ring in its groove.
● Apply grease to the driven face bore areas (9~9.5g)
SERVICE LIMIT : 39.85mm replace if below
SERVICE LIMIT : 40.06mm replace if over
pulley face.
of the driven face.
sealed end facing up.
8-9