DAELIM S2-250 Service Manual page 138

COUNTERSHAFT COUNTERSHAFT COUNTERSHAFT
COUNTERSHAFT COUNTERSHAFT COUNTERSHAFT COUNTERSHAFT
COUNTERSHAFT COUNTERSHAFT COUNTERSHAFT COUNTERSHAFT
COUNTERSHAFT COUNTERSHAFT COUNTERSHAFT COUNTERSHAFT COUNTERSHAFT COUNTERSHAFT
COUNTERSHAFT
OIL CHECK BOLT HOLE
OIL CHECK BOLT HOLE OIL CHECK BOLT HOLE OIL CHECK BOLT HOLE OIL CHECK BOLT HOLE OIL CHECK BOLT HOLE OIL CHECK BOLT HOLE
OIL CHECK BOLT HOLE OIL CHECK BOLT HOLE OIL CHECK BOLT HOLE OIL CHECK BOLT HOLE
OIL CHECK BOLT HOLE OIL CHECK BOLT HOLE OIL CHECK BOLT HOLE OIL CHECK BOLT HOLE
OIL CHECK BOLT HOLE OIL CHECK BOLT HOLE OIL CHECK BOLT HOLE
DRAIN BOLT DRAIN BOLT DRAIN BOLT DRAIN BOLT DRAIN BOLT
DRAIN BOLT DRAIN BOLT
DRAIN BOLT DRAIN BOLT DRAIN BOLT DRAIN BOLT DRAIN BOLT DRAIN BOLT
DRAIN BOLT DRAIN BOLT DRAIN BOLT DRAIN BOLT DRAIN BOLT
● Install the countershaft and gear into the left crankcase.
● Install the resin washer onto the counter-shaft.
● Install the dowel pins and a new gasket.
● Install the transmission case cover.
● Install and tighten the transmission case cover bolts.
● Install the clutch/dirven pulley.
● Install other removed parts in the reverse order of
removal.
● After installation, fill the ransmission case with the
specified oil.
•Place the motorcycle on its main stand on level
ground.
•Check the oil-sealing washer for wear or damage.
● After installation, fill the ransmission case with the
specified oil.
SPECIFIED GEAR OIL : SAE90#
OIL CAPACITY :
At disassembly : 0.2
At change : 0.18
● Install and tighten the oil check bolt.
TORQUE VALUE : 0.78~1.18kgf·m
● Start the engine and check for oil leaks.
● Check the oil level from the oil check bolt hole and add
the specified oil to the proper level if the oil level is
low.
FINAL REDUCTION
13-5