DAELIM S2-250 Service Manual page 88

8. LH. CRANKCASE COVER/CONTINUOUSLY
VARIABLE TRANSMISSION
SERVICE INFORMATION· · · · · · 8-1
TROUBLESHOOTING· · · · · · · · · · 8-1
LH. SIDE COVER REMOVAL· · 8-2
SERVICE INFORMATION
● Do not allow oil to contact the drive belt or the pulley face. The transmission rate of driving force is reduced with oil contact.
● Do not operate starter motor while the L. crank case front cover is removed.
SPECIFICATIONS
ITEM
MOVABLE DRIVE FACE BUSHING INNER DIAMETER
DRIVE FACE COLLAR OUTER DIAMETER
DRIVE BELT WIDTH
CLUTCH LINING WICTH
CLUTCH OUTER AND INNER DIAMETER
WEIGHT ROLLER OUTER DIAMETER
DRIVEN FACE BOSS OUTER DIAMETER
MOVABLE DRIVEN FACE INNER DIAMETER
TORQUE VALUES :
DRIVE FACE NUT
CLUTCH OUTER NUT
CLUTCH DIRVE PLATE NUT
TROUBLESHOOTING
Engine starts but motorcycle does not work.
● Drive belt worn.
● Ramp plate damaged.
● Clutch shoe worn or damaged.
● Movable driven face spring cut.
Engine stops, or the vehicle runs suddenly,
after starting.
● Clutch shoe spring cut.
STANDARD
40.000~40.025mm
39.965~39.955mm
23.6~24.4mm
3.963~4.037mm
153.0~153.2mm
22.92~23.08mm
26.960~26.974mm
27.052~26.989mm
: 8.82~9.8㎏f·m
: 4.9~5.88㎏f·m
: 4.9~5.88㎏f·m
DRIVE PULLY· · · · · · · · · · · · · · · · · · 8-3
CLUTCH DRIVEN PULLY· · · · · · 8-7
Vehicle unable to run at the maximum speed,
or lack of output
● Drive belt worn.
● Defective movable driven face spring.
● Weight roller worn.
● Pulley face contaminated.
SERVICE LIMIT
40.06mm
39.85mm
22.0mm
2.0mm
153.5mm
22.0mm
26.90mm
27.13mm
8-1
8