Thermosensor - DAELIM S2-250 Service Manual

BOLTS BOLTS BOLTS BOLTS BOLTS
BOLTS BOLTS BOLTS BOLTS BOLTS BOLTS
BOLTS BOLTS
BOLTS BOLTS BOLTS BOLTS BOLTS

THERMOSENSOR

THERMOSENSOR THERMOSENSOR
THERMOSENSOR THERMOSENSOR THERMOSENSOR THERMOSENSOR
THERMOSENSOR THERMOSENSOR THERMOSENSOR THERMOSENSOR
THERMOSENSOR THERMOSENSOR THERMOSENSOR THERMOSENSOR
THERMOSENSOR THERMOSENSOR THERMOSENSOR
DOWEL PIN DOWEL PIN DOWEL PIN
DOWEL PIN DOWEL PIN DOWEL PIN DOWEL PIN
DOWEL PIN DOWEL PIN DOWEL PIN DOWEL PIN DOWEL PIN DOWEL PIN
DOWEL PIN DOWEL PIN DOWEL PIN DOWEL PIN
DOWEL PIN
BOLTS BOLTS BOLTS
BOLTS BOLTS BOLTS BOLTS
BOLTS BOLTS BOLTS BOLTS BOLTS BOLTS
BOLTS BOLTS BOLTS BOLTS BOLTS
COOLING SYSTEM
● Install the impeller onto the water pump shaft.
TORQUE VALUE : 0.98~1.37kgf·m
·The impeller has left hand thread.
● Install the 2 dowel pins and a new gasket.
● Install the water pump cover and tighten the 4 bolts.
TORQUE VALUE : 0.78~1.18kgf·m
THERMOSENSOR
REMOVAL
● Remove the seat, met-in box and center cover.
● Drain the coolant.
● Disconnect the thermosensor wire.
● Remove the thermosensor.
6-11