DAELIM S2-250 Service Manual page 48

OIL LEVEL GAUGE OIL LEVEL GAUGE OIL LEVEL GAUGE
OIL LEVEL GAUGE OIL LEVEL GAUGE OIL LEVEL GAUGE OIL LEVEL GAUGE
OIL LEVEL GAUGE OIL LEVEL GAUGE OIL LEVEL GAUGE OIL LEVEL GAUGE
OIL LEVEL GAUGE OIL LEVEL GAUGE OIL LEVEL GAUGE OIL LEVEL GAUGE
OIL LEVEL GAUGE OIL LEVEL GAUGE OIL LEVEL GAUGE
OIL DRAIN BOLT OIL DRAIN BOLT OIL DRAIN BOLT
OIL DRAIN BOLT OIL DRAIN BOLT OIL DRAIN BOLT OIL DRAIN BOLT
OIL DRAIN BOLT OIL DRAIN BOLT OIL DRAIN BOLT OIL DRAIN BOLT OIL DRAIN BOLT OIL DRAIN BOLT
OIL DRAIN BOLT OIL DRAIN BOLT OIL DRAIN BOLT OIL DRAIN BOLT
OIL DRAIN BOLT
TAPPET ADJUSTING HOLE CAP TAPPET ADJUSTING HOLE CAP TAPPET ADJUSTING HOLE CAP TAPPET ADJUSTING HOLE CAP TAPPET ADJUSTING HOLE CAP
TAPPET ADJUSTING HOLE CAP TAPPET ADJUSTING HOLE CAP TAPPET ADJUSTING HOLE CAP TAPPET ADJUSTING HOLE CAP TAPPET ADJUSTING HOLE CAP TAPPET ADJUSTING HOLE CAP
TAPPET ADJUSTING HOLE CAP TAPPET ADJUSTING HOLE CAP
TAPPET ADJUSTING HOLE CAP TAPPET ADJUSTING HOLE CAP TAPPET ADJUSTING HOLE CAP TAPPET ADJUSTING HOLE CAP TAPPET ADJUSTING HOLE CAP
LUBRICATION SYSTEM
ENGINE OIL LEVEL INSPECTION
● Erect the motorcycle on the main stand.
● Warm up the engine to heat the engine oil to an
appropriate level.
● Stop the engine, and check the oil level line on the
sight-glass installed on the LH. crank case cover.
● If the oil level is between the lower and higher sight-
glass oil level line, oil level is satisfactory. If the oil
level is below or near the lower level mark, add the
recommended engine oil.
ENGINE OIL CHANGE
•To completely and rapidly drain engine oil, warm up
engine and erect the motorcycle on its side stand.
● Loosen the oil drain plug bolt and drain engine oil.
● Tighten the oil drain plug bolt.
TORQUE VALUE : 1.4 kgf·m
•It is extremely important to replace oil filter or clean
the oil filter screen at the first maintenance interval
(after 1,000Km).
•Clean the oil filter screen every 4,000Km.
•Clean the filter screen with fresh cleaning oil.
•Check the hole cap O-ring for satisfactory condition.
•Tighten the hole cap with specified tightening
torque.
TORQUE VALUE : 1.5 kgf·m
● Loosen the special screw, remove the plug maintenance
cover.
● Fill the recommended oil after opening oil filter cap of
cylinder head cover.
OIL CAPACITY : 1.1ℓ(After disassembly)
0.9ℓ(After Oil change)
0.95ℓ(After Oil filter change)
● API service classification : SJ grade.
● Start the engine and keep it idle for a few minutes.
● Stop the engine and check the oil level. If the oil level
is low, add the recommended engine oil.
● Check on oil leaks.
4-3