DAELIM ROADWIN VJ125 Service Manual page 128

BOLTS
BOLTS BOLTS BOLTS BOLTS
BOLTS BOLTS BOLTS BOLTS
BOLTS BOLTS BOLTS BOLTS
BOLTS BOLTS BOLTS
O-RING O-RING O-RING O-RING O-RING
O-RING O-RING O-RING O-RING O-RING O-RING
O-RING O-RING
O-RING O-RING O-RING O-RING O-RING
PIN PIN PIN PIN PIN
PIN PIN
PIN PIN PIN PIN PIN PIN
PIN PIN PIN PIN PIN
BOLT BOLT BOLT BOLT BOLT
BOLT BOLT BOLT BOLT BOLT BOLT
BOLT BOLT
BOLT BOLT BOLT BOLT BOLT
GEAR SHIFT DRUM HOLE GEAR SHIFT DRUM HOLE GEAR SHIFT DRUM HOLE GEAR SHIFT DRUM HOLE GEAR SHIFT DRUM HOLE
GEAR SHIFT DRUM HOLE GEAR SHIFT DRUM HOLE GEAR SHIFT DRUM HOLE GEAR SHIFT DRUM HOLE GEAR SHIFT DRUM HOLE GEAR SHIFT DRUM HOLE
GEAR SHIFT DRUM HOLE GEAR SHIFT DRUM HOLE
GEAR SHIFT DRUM HOLE GEAR SHIFT DRUM HOLE GEAR SHIFT DRUM HOLE GEAR SHIFT DRUM HOLE GEAR SHIFT DRUM HOLE
GEAR CHANGE SWITCH GEAR CHANGE SWITCH GEAR CHANGE SWITCH
GEAR CHANGE SWITCH GEAR CHANGE SWITCH GEAR CHANGE SWITCH GEAR CHANGE SWITCH
GEAR CHANGE SWITCH GEAR CHANGE SWITCH GEAR CHANGE SWITCH GEAR CHANGE SWITCH
GEAR CHANGE SWITCH GEAR CHANGE SWITCH GEAR CHANGE SWITCH GEAR CHANGE SWITCH
GEAR CHANGE SWITCH GEAR CHANGE SWITCH GEAR CHANGE SWITCH
CRANKCASE/TRANSMISSION/CRANKSHAFT
Install the right crankcase into the left crankcase .
Make sure that there is no gap between the
mating surfaces of the right and left crankcase.
Tighten the left crankcase bolts in a crisscross
pattern in 2-3 steps.
TORQUE : 1.1kgf m(11N m)
Tighten the right crankcase bolt to the specified
torque.
TORQUE : 1.1kgf m(11N m)
After replacing the o-ring of the gear change switch
to a new one, coat the new o-ring with engine oil,
then install the switch pin into the groove of the
shift drum.
11-11