INSPECTIONS / ADJUSTMENTS
WEAR
INDICATOR
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
LOWER LEVEL LINE
2-10
WEAR INDICATOR
DRIVE CHAIN SLIDER
Inspect the drive chain slider for excessive wear or
damage.
If it is worn to the wear indicator, replace the drive
chain slider.
BRAKE FLUID
Do not mix a dust or different types of fluid when
filling the brake fluid.
Mind that the reservoir is level in checking and
filling it.
Avoid spilling the fluid on painted, plastic, or
rubber parts.
When the fluid level is low, check the brake pads
for wear. If the brake pads are not worn and the
fluid level is low, check entire system for leaks.
( 2-11)
FRONT BRAKE
Turn the handlebar so that the reservoir is level and
check the front brake fluid reservoir level.
If the level is near the lower level line, check the brake
pad wear.
REAR BRAKE
Place the motorcycle on a level surface, and support it
upright position.
Check the rear brake fluid reservoir level.
If the level is near the lower level line, check the brake
pad wear.
BRAKE PAD WEAR
FRONT BRAKE PADS
Check the brake pads for wear.
Replace the brake pads if either pad is worn to the
bottom of wear limit groove.
Refer to page 15-6 for brake pad replacement.