Crankcase Removal; Crankcase Inspection - DAELIM ROADWIN VJ125 Service Manual

CRANKCASE/TRANSMISSION/CRANKSHAFT
UNIVERSAL BEARING PULLER
UNIVERSAL BEARING PULLER UNIVERSAL BEARING PULLER
UNIVERSAL BEARING PULLER
UNIVERSAL BEARING PULLER UNIVERSAL BEARING PULLER
UNIVERSAL BEARING PULLER
RIGHT
80mm
11-6
CRANKSHAFT CRANKSHAFT CRANKSHAFT CRANKSHAFT CRANKSHAFT
CRANKSHAFT CRANKSHAFT CRANKSHAFT CRANKSHAFT CRANKSHAFT CRANKSHAFT
CRANKSHAFT CRANKSHAFT CRANKSHAFT CRANKSHAFT
CRANKSHAFT CRANKSHAFT CRANKSHAFT
UNIVERSAL BEARING PULLER UNIVERSAL BEARING PULLER
UNIVERSAL BEARING PULLER UNIVERSAL BEARING PULLER
UNIVERSAL BEARING PULLER UNIVERSAL BEARING PULLER UNIVERSAL BEARING PULLER
UNIVERSAL BEARING PULLER UNIVERSAL BEARING PULLER
UNIVERSAL BEARING PULLER UNIVERSAL BEARING PULLER
LEFT
70mm
FEELER GAUGE
CRANKSHAFT
REMOVAL
Remove the transmission. ( 11-4)
Remove the crankshaft from the left crankcase
using a crankshaft separating tool.
Remove the remaining bearings in the left
crankcase with a driver handle and outer driver.
TOOLS : DRIVER
ATTACHMENT, 42 X 47 mm
If the bearing is left on the crankshaft, use a bearing
puller to remove it.
TOOL : UNIVERSAL BEARING PULLER
After removing the crankshaft from the LH.
crankcase, replace the LH. crankshaft bearing with a
new one.
INSPECTION
Place the crankshaft on a stand or V-block, and measure
the crankshaft runout using dial gauge.
SERVICE LIMIT : RIGHT : 0.100 mm
LEFT : 0.100 mm
Measure the side clearance by inserting the feeler
gauge between the crankshaft and connecting rod big
end as shown.
SERVICE LIMIT : 0.600mm
TOOL : FEELER GAUGE