Crankchaft Installation - DAELIM ROADWIN VJ125 Service Manual

CRANKCASE/TRANSMISSION/CRANKSHAFT
COOLING JET COOLING JET COOLING JET COOLING JET COOLING JET
COOLING JET COOLING JET
COOLING JET COOLING JET COOLING JET COOLING JET COOLING JET COOLING JET
COOLING JET COOLING JET COOLING JET COOLING JET COOLING JET
11-8
BEARING SET PLATE BEARING SET PLATE BEARING SET PLATE
BEARING SET PLATE BEARING SET PLATE
BEARING SET PLATE BEARING SET PLATE BEARING SET PLATE BEARING SET PLATE BEARING SET PLATE BEARING SET PLATE
BEARING SET PLATE BEARING SET PLATE BEARING SET PLATE BEARING SET PLATE
BEARING SET PLATE
RH. Crank Case
Remove the main shaft bearing set plate.
Remove the main shaft bearing, counter shaft
bearing and crank shaft bearing form crankcase.
Coat the new bearing with clean engine oil and
install it into crankcase.
Insert closely the cooling jet into crankcase.
- Insert angle: 10 2
TOOLS :
MAIN SHAFT BEARING :
- DRIVER / ATTACHMENT, 42
PILOT, 20mm
COUNTER SHAFT BEARING :
- DRIVER / ATTACHMENT, 32
PILOT, 15mm
CRANK SHAFT BEARING :
- DRIVER / ATTACHMENT, 62
PILOT, 28mm
Coat the socket bolt screw part with oil and install
the main shaft bearing set plate.
TORQUE : 1.2kgf m (12N m)
CRANKSHAFT INSTALLATION
Coat a new left crankshaft bearing with clean
engine oil and install new bearings into the right
crankcase.
TOOLS : DRIVER
ATTACHMENT, 72
PILOT, 35mm
Install the crankshaft into the left crankcase with
the following tools:
TOOLS : THREAD ADAPTER
ASSEMBLY SHAFT
CRANKSHAFT ASSEMBLY COLLAR
47mm /
35mm /
68mm /
78mm