Mmls_Rate Messages; Mmls_Rate-3; Mrib_Proxy Messages; Mrib_Proxy-2 - Cisco III - Supervisor Engine III Message Manual

Chapter 2 Messages and Recovery Procedures
Error Message %MMLS-6-VLAN_ADD_FAILURE_ON_MET_FULL: Error adding vlan [dec] to the
MET table of some shortcuts

MMLS_RATE Messages

This section contains Multicast Multilayer Switching Rate Limiting (MMLS_RATE) messages.

MMLS_RATE-3

Error Message %MMLS_RATE-3-MMLS_PARTIAL_SC_ERROR: Error installing Multicast
Partial-sc rate-limiter.Operation failed.

MRIB_PROXY Messages

This section contains Multicast Routing Information Base proxy (MRIB_PROXY) messages.

MRIB_PROXY-2

Error Message %MRIB_PROXY-2-MRIB_LC_CREPRC_FAILED: LC in slot [dec] failed to create
a required process.
OL-11469-02
Explanation The MET is full. The system is unable to add the specified VLAN to some shortcuts.
The affected shortcuts will not switch traffic for that VLAN.
The MET utilization is very high and needs to be brought down by removing
Recommended Action
some VLANs or switching to ingress replication mode.
Explanation The multicast partial-sc rate limiter could not be configured because of an error that was
returned from the switch processor.
Recommended Action The LTL index for the partial-sc rate limiter might not have initialized yet. Wait
several minutes, and try to configure the rate limiter again.
The line card could not create a process to perform delayed IPC initialization. The
Explanation
MFIB will not be started on this line card.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
MMLS_RATE Messages
2-179