Network_Rf_Api-3; Oir Messages - Cisco III - Supervisor Engine III Message Manual

Chapter 2 Messages and Recovery Procedures

NETWORK_RF_API-3

Error Message %NETWORK_RF_API-3-FAILDECODEDATADESCINSTDBY: Cannot decode data
descriptor in Standby for [chars], descriptor type=[dec]
Error Message %NETWORK_RF_API-3-IPC: [chars] [chars]

OIR Messages

This section contains online insertion and removal (OIR) messages.
OL-11469-02
An internal data descriptor could not be decoded by the standby device. This message
Explanation
identifies the interface or controller that caused the decoding failure in the standby device. This
interface was encoded in the active device but could not be decoded in the standby device. This
failure probably occurred because of a software error.
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
An IPC error occurred. Additional details on the nature of the error are specified in the
Explanation
message text on the console or in the system log.
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OIR Messages
2-183