Mls_Rate Messages; Mls_Rate-4 - Cisco III - Supervisor Engine III Message Manual

MLS_RATE Messages

Error Message %MLSM-6-MMLS_NO_EGRESS_LOCAL_IN_INGRESS: MMLS: Egress Local feature is
NOT applicable in Ingress mode
MLS_RATE Messages
This section contains Multilayer Switching Rate Limit (MLS_RATE) messages.

MLS_RATE-4

Error Message %MLS_RATE-4-CPP_DISABLED_IN_HW: Control Plane Policing NOT performed
in hardware, due to the presence of egress QoS.
Error Message %MLS_RATE-4-CPP_RE_ENABLED_IN_HW: Control Plane Policing will now be
performed in hardware.
Error Message %MLS_RATE-4-DISABLING: The Layer2 Rate Limiters have been disabled.
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
2-174
Explanation When the system transitions from egress replication mode to ingress mode, the egress
local feature will not be applied, even if the egress local feature is enabled.
If the egress local feature is required, restore the system replication mode to
Recommended Action
egress.
Explanation CPP cannot be performed in the hardware when the system is running in PFC3A mode
and egress QoS is configured on any other interface. Under these circumstances, CPP is performed
only in the software until egress QoS is removed from the running configuration.
Remove any egress QoS from the running configuration, or upgrade to a
Recommended Action
PFC3B or PFC3-BXL. We strongly recommend the upgrade.
CPP cannot be performed in the hardware when the system is running in PFC3A mode
Explanation
and egress QoS is configured on any other interface. Egress QoS has been removed from the running
configuration.
Because egress QoS has been removed, no action is required. To prevent this
Recommended Action
condition from occurring again, we strongly recommend that you upgrade to a PFC3B or PFC3BXL.
This feature is turned off with the current hardware configuration. The Layer 2 rate
Explanation
limiters are not supported with this combination of modules.
Refer to the feature usage guidelines for more details.
Recommended Action
Chapter 2 Messages and Recovery Procedures
OL-11469-02