C6K_Mpls_Lc Messages; C6K_Mpls_Lc-3 - Cisco III - Supervisor Engine III Message Manual

Chapter 2 Messages and Recovery Procedures
Error Message %C6K_MPLS_COMMON-3-L3_CONFIG_NOT_RECOMMENDED: LAN interfaces are
facing the MPLS Core. Do not configure xconnect on interface vlans.
Error Message %C6K_MPLS_COMMON-3-OSM_BB1_CONFIG_UNSUPPORTED: The maximum label
range configured for this system exceeds the [int] limit supported by the module
in slot [int]. For proper MPLS functionality on any of the interfaces on this
module the maximum label range should be set to [int].
Error Message %C6K_MPLS_COMMON-3-VPLS_CONFIG_EXCEEDED: The number of EoMPLS/VPLS VCs
exceeded the maximum supported on [IP_address]/[int].

C6K_MPLS_LC Messages

This section contains Catalyst 6500 series switch and Cisco 7600 series router Multiprotocol Label
Switching (MPLS) switch processor or module (C6K_MPLS_LC) messages.

C6K_MPLS_LC-3

Error Message %C6K_MPLS_LC-3-MALLOCFAIL: failed to create [chars]
OL-11469-02
Explanation An attempt was made to configure a cross-connection service on an interface VLAN.
The current network configuration has MPLS configured on a LAN interface that is facing the MPLS
core.
Recommended Action Do not configure cross-connection services on an interface VLAN if the
network has MPLS configured on a LAN interface.
Explanation The OSM cannot support the MPLS label range configured for this system.
Change the maximum MPLS label range by using the mpls label range
Recommended Action
command.
Explanation The number of destination routers or the global number of virtual circuits exceeded the
maximum limit supported by the device.
Refer to network configuration guidelines for the maximum limits.
Recommended Action
Explanation The system failed to allocate memory for an MPLS entry for the incoming label. Some
MPLS packets might be forwarded by the software.
Recommended Action Reduce other system activity to ease memory demands. If necessary, increase
system memory. When more memory is available, wait for a few minutes and enter the clear ip
route command. If sufficient memory has not been made available, this message will be displayed
again. If this problem persists, contact your Cisco technical support representative.
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
C6K_MPLS_LC Messages
2-11