Pm Messages; Pm-1; Pm-4 - Cisco III - Supervisor Engine III Message Manual

PM Messages

Error Message %PISAL2M-6-NBAR_PD_ACCEL_ENABLED: Protocol Discovery accelerated on
[chars] direction of: [chars]
Error Message %PISAL2M-6-NBAR_TAGGING_DISABLED: NBAR protocol Tagging disabled on
[chars] direction of: [chars]
Error Message %PISAL2M-6-NBAR_TAGGING_ENABLED: NBAR protocol Tagging enabled on
[chars] direction of: [chars]
PM Messages
This section contains port manager (PM) messages.

PM-1

Error Message %PM-1-INCONSISTENT_PORT_STATE: Inconsistent HW/SW port state for
[chars]. Please shut/no shut the interface

PM-4

Error Message %PM-4-MPLS_MTU_EC_CFG: MPLS MTU size [dec] is not supported by one or
more ports in channel [chars].
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
2-204
Explanation NBAR protocol discovery acceleration is enabled. This traffic will be sent to PISA.
No action is required.
Recommended Action
NBAR protocol tagging is disabled. This traffic will not be sent to PISA.
Explanation
No action is required.
Recommended Action
NBAR protocol tagging is enabled. This traffic will be sent to PISA.
Explanation
No action is required.
Recommended Action
The hardware and software port state has become inconsistent. [chars] is the interface.
Explanation
No action is necessary. This message is for informational purposes only.
Recommended Action
The MPLS MTU size that was configured on the Ethernet channel is larger than the
Explanation
maximum MTU size that can be supported by one or more ports in this channel. Large packets might
be dropped.
Reduce the MPLS MTU size, or remove these ports from the channel before
Recommended Action
increasing the MPLS MTU size.
Chapter 2 Messages and Recovery Procedures
OL-11469-02