Cisco AIR-PCM340 Installation And Configuration Manual page 135

Aironet wireless lan adapters
Table of Contents

Advertisement

Chapter 7
Performing Diagnostics
Table 7-5 describes the parameters on the status screen.
Table 7-5
Parameter
Firmware Version
Channel
World Mode Carrier Set
Product Name
MAC Address
Data Rate
Packets Transmitted
Packets Received
Total Receive Errors
Signal Strength
Signal Quality
OL-1377-01
Client Adapter Status Screen Parameters
Description
The version of the radio firmware that is currently running on your
client adapter.
Specifies which frequency your client adapter will use as the channel
for communications. These channels conform to the IEEE 802.11
Standard for your regulatory domain.
In infrastructure mode, this parameter is set automatically and
cannot be changed. The client adapter listens to the entire
spectrum, selects the best access point to associate to, and uses the
same frequency as that access point.
In ad hoc mode, the channel of the client adapter must be set to
match the channel used by the other clients with which you wish to
communicate.
Range: Dependent on regulatory domain
Note
When world mode is enabled and your client adapter has associated to
an access point, this is the channel set adopted by the adapter from the
access point.
Value: Disabled, Unknown, North America, Europe, Japan, Spain,
Identifies the type of client adapter you are using.
Value: 340 Series, 350 Series, or 4800 Series
The MAC address assigned to your client adapter at the factory.
The rate at which your client adapter is currently transmitting data
packets.
Value: 1 Mbps, 2 Mbps, 5.5 Mbps, or 11 Mbps
The number of packets that have been transmitted successfully.
The number of packets that have been received successfully.
The total number of errors on receive packets.
The signal strength for received packets. The longer the bar graph is,
the stronger the signal.
The signal quality for received packets. The longer the bar graph is, the
better the signal quality.
Cisco Aironet Wireless LAN Adapters Installation and Configuration Guide for Mac OS
Example: 1 to 11 (2412 to 2462 MHz) in North America
Refer to
Appendix
D, "Channels and Antenna Settings" for
a list of channel identifiers, channel center frequencies, and
regulatory domains for each channel.
France, Belgium, Israel, Canada, Australia
Diagnostic Tools for Mac OS X
7-17

Advertisement

Table of Contents
loading

This manual is also suitable for:

340 series350 series

Table of Contents