Inserting The Client Adapter Into A Computing Device; Inserting A Pc Card - Cisco AIR-PCM340 Installation And Configuration Manual

Inserting the Client Adapter into a Computing Device

Step 18 Perform one of the following operations:
•
•
•
•
Step 19 Click Apply Now to apply your TCP/IP configuration options.
Step 20 Click System Prefs on the main menu bar and click Quit System Prefs.
Note To uninstall the client utilities, follow the instructions in the
Utility" section on page
You have completed the basic configuration of your client adapter. To verify a successful installation,
refer to the

Inserting the Client Adapter into a Computing Device

This section provides instructions for inserting a PC card or a PCI client adapter into an Apple Macintosh
computing device.

Inserting a PC Card

Step 1 Before you begin, examine the PC card. One end has a dual-row, 68-pin PC card connector. The card is
keyed so it can be inserted only one way into the PC card slot.
Note
Step 2 Hold the PC card with the Cisco logo facing up and insert it into the PC card slot, applying just enough
pressure to make sure it is fully seated (see
Do not force the PC card into your computer's PC card slot. Forcing it will damage both the card and
Caution
the slot. If the PC card does not insert easily, remove the card and reinsert it.
Cisco Aironet Wireless LAN Adapters Installation and Configuration Guide for Mac OS
3-8
If you are connected to a DHCP server, select Using DHCP in the Configure drop-down box and
type your computer's unique client name in the DHCP Client ID field. If required by your wireless
network, enter the IP addresses for the domain name servers (obtained from your system
administrator).
If you need to specify a fixed IP address when using your DHCP server, select Using DHCP with
fixed IP Address in the Configure drop-down box and enter the client adapter IP address. If required
by your wireless network, enter the IP addresses for the domain name servers (obtained from your
system administrator).
If you are connected to a BootP server, select Using BootP in the Configure drop-down box. If
required by your wireless network, enter the IP addresses for the domain name servers (obtained
from your system administrator).
If you are not connected to a DHCP or BootP server, select Manually in the Configure drop-down
box and enter the client adapter IP address, the subnet mask, and the router IP address. If required
by your wireless network, enter the IP addresses for the domain name servers (obtained from your
system administrator).
8-4.
"Verifying a Successful Installation and Configuration on Mac OS X" section on page
The PC card slot is on the left side of the computer, depending on the model.
Chapter 3 Installing the Driver, Client Utility, and Client Adapter
"Removing the Driver and Client
Figure 3-3).
3-15.
OL-1377-01