Cisco AIR-PCM340 Installation And Configuration Manual page 87

Chapter 5 Advanced Configuration on Mac OS 9.x
Table 5-7
Parameter
Enable LEAP for Home
Network
Enable WEP for Home
Network
Home Network Type
OL-1377-01
Home Networking Parameters (continued)
Description
Enables or disables LEAP for your client adapter.
If you want to enable LEAP for your client adapter, you must select this
check box and set a username and password. Refer to Chapter 4, "Security
Features" for more information about LEAP and instructions on setting a
LEAP username and password.
Note This check box can also be used to disable or enable LEAP after
it is enabled.
Default: Deselected
Enables or disables WEP for your client adapter.
If you want to enable WEP for your client adapter, you must select this
•
check box and create a WEP key. Refer to the Chapter 4, "Security
Features" for more information on WEP and instructions on setting a
WEP key.
Note This check box can also be used to disable or enable WEP after
it is enabled.
• If you enable LEAP for your client adapter, this check box is selected
automatically.
Default: Deselected
40-bit client adapters cannot be used with the Cisco Aironet 340
Note
Series Base Station.
Specifies the type of network in which your client adapter is installed.
Default: Infrastructure
Home Network Type
Ad Hoc
Infrastructure
Cisco Aironet Wireless LAN Adapters Installation and Configuration Guide for Mac OS
Configuring Your Client Adapter
Description
Also referred to as peer to peer. Used to set up a
small network between two or more devices. For
example, a network without a base station could be
set up between computers in a room so information
can be shared.
Used to set up a connection to a wired Ethernet
network (through a base station).
5-23