Verifying Installation - Cisco AIR-PCM340 Installation And Configuration Manual

Chapter 4 Security Features
Step 7 Click Apply when you have finished entering your username and password.
After LEAP is enabled, your client adapter authenticates to the RADIUS server using your LEAP username
and password and receives a session-based WEP key.
Note When you enable LEAP, the Enable WEP check box is automatically checked. This indicates that
dynamic, session based WEP is active. You do not have to enter a static WEP key.
Note You can disable LEAP at any time by deselecting the Enable LEAP check box, but to enable LEAP
again, you will have to reenter your LEAP username and password.

Verifying Installation

To verify that you have properly installed the driver and client utility, perform the following:
Step 1 From the Finder menu bar, click Go and select Applications. The applications screen appears.
Step 2 Double-click the Aironet Client Utility icon. The client utility screen appears.
If the installation was successful, the client utility successfully detects the client adapter radio and your
client adapter associates to an access point and provides its IP address (check the bottom of the client
utility basic properties screen).
Note If your installation was unsuccessful or you experienced problems during or after driver installation,
refer to
OL-1377-01
Chapter 9, "Troubleshooting."
Cisco Aironet Wireless LAN Adapters Installation and Configuration Guide for Mac OS
Security Options for Mac OS X
4-17