Table of Contents
Advertisement
Chapter 5
Advanced Configuration on Mac OS 9.x
Note
The firmware image file available online is a compressed file and you must expand (uncompress) the
file before you can use it.
Follow the instructions below to expand the compressed file and load the new firmware into your client
adapter.
Note
If a power failure occurs while you are loading new firmware, your client adapter may become
inoperable. If this occurs, start the procedure again.
Step 1
Locate and use the Stuffit Expander program on your hard drive to expand (uncompress) the radio
firmware image file you copied to your hard drive. This creates an image file (filename.img) in the folder
where the compressed file is located.
Step 2
Make sure the client adapter is installed in your computer and is operational.
Step 3
Select Load Firmware from the Edit pull-down menu (see Figure 5-3). The Firmware window appears
(see Figure 5-4).
Figure 5-3
Figure 5-4
Step 4
Under Name, select the location of the new firmware (for example, Macintosh HD).
OL-1377-01
Edit Pull-Down Menu
Firmware Window
Cisco Aironet Wireless LAN Adapters Installation and Configuration Guide for Mac OS
Loading New Firmware
5-5
Advertisement
Table of Contents
Troubleshooting
