Using the Client Utility on Mac OS X
Using the Client Utility on Mac OS X
This section explains how to use the client utility to load new firmware and to configure your client
adapter for use in a wireless network. This section also explains how you can use the client utility to set
parameters that govern how the adapter transmits or receives data, and controls the adapter's operation
within an infrastructure or ad hoc network.
Opening the Client Utility
To open the client utility, follow the steps below.
From the Finder menu bar on the top of the screen, select Go and click Applications (see Figure 6-1).
Step 1
The Applications screen appears.
Figure 6-1
On the Applications screen, double-click the Aironet Client Utility icon. The client utility screen
Step 2
appears, and the computer searches for the client adapter radio. When the radio is found, the basic
properties screen appears (see Figure 6-2).
Cisco Aironet Wireless LAN Adapters Installation and Configuration Guide for Mac OS
6-2
Finder Menu Bar
Chapter 6
Advanced Configuration on Mac OS X
OL-1377-01