Removing the Standalone Cosmetic Cover
If the autoloader is not rackmounted and has a cosmetic cover, to remove
the cover, do the following:
CAUTION
This autoloader contains very sensitive elctronic components. It is
important to prevent electrostatic discharge (ESD). Use wrist grounding
straps and anti-static mats when removing and replacing cards and
internal assemplies.
1. Remove the four T-15 screws (see Figure 1-4).
2. Lift the autoloader cover off by easing the sides out and lifting it up
3. The autoloader is now ready for upgrading (see "Upgrading the
Figure 1-4
Removing the Standalone Cosmetic Cover
Chapter 1
from the chassis.
Autoloader from DLT to Ultrium" on page 2-9).
Overview and Preparation for Upgrade
Removing a Rackmounted Autoloader (if necessary)
O v
e r
v i
e w
&
P r
e p
a r
a t
i o
n
1-7