Installing the Remote Management Card (RMC)
Use proper procedures to prevent electrostatic discharge (ESD) Use
CAUTION
wrist-grounding straps and anti-static mats.
1. Power-off the autoloader and disconnect the power cord.
2. Remove the panel that covers the slot for the remote management
Figure 2-1
Installing a Remote Management Card
3. Align the sides of the new RMC with the recessed guide tracks inside
4. Gently slide the RMC in, ensuring that it remains aligned with the
5. Tighten the two thumbscrews on the RMC to secure it to the
6. Reconnect the power cord and power-on the autoloader.
7. Download new firmware (see "Upgrading Firmware" on page 4-3).
Chapter 2
card (see Figure 2-1).
the autoloader. The card fits between the top and bottom tracks (see
Figure 2-1).
recessed guide tracks. There may be some resistance as the RMC
connector engages with the connector on the autoloader.
autoloader.
Upgrading the Autoloader
Web Monitoring
2-5
U p
g r
a d
i n
g
t h
e
A u
t o
l o
a d
e r