HP C7745NB - SureStore DLT Tape Autoloader 1/9 Manual page 32

Figure 2-6
Upgrading the Autoloader
Upgrading the Autoloader from DLT to Ultrium
3. The back magazine will be visible in the opening (see Figure 2-5 on
page 2-13).
4. Through the side access opening, carefully reach into the autoloader
and hold the back magazine in place while removing the T-15 screw
on the exterior of the autoloader (see Figure 2-6). Removing this
screw will release the back magazine.
5. Grasp the empty magazine by the slots and noting the location of the
upper and lower tabs on the magazine, gently slide the magazine to
the left until it is free from the tracks and remove it through the side
access opening (see Figure 2-7 on page 2-15).
Removing the Back Magazine
2-14 Chapter 2