Figure 3-4 Removing The Front Magazine - HP C7745NB - SureStore DLT Tape Autoloader 1/9 Manual

Hp surestore tape autoloader model 1/9 upgrade and parts replacement guide

Hide thumbs Also See for C7745NB - SureStore DLT Tape Autoloader 1/9:

Table of Contents

5. To prevent damage, lock the transport by running the

Figure 3-4

Removing the Front Magazine

Be sure to also remove the tapes from the internal back magazine.

NOTE

CAUTION

Do not power-off the autoloader until the interface is inactive. Removing

power from a SCSI peripheral when the bus is active can result in data

loss and/or indeterminate bus states. If your computer is connected to a

LAN, be sure to check with your system administrator before powering-

off.

6. Power-off the autoloader. The power "standby" switch is recessed to

7. Remove the drive module by following the procedures in "Removing

8. Remove and keep all external cords, cables, and terminators.

Chapter 3

front panel test.

avoid accidental power cycles. Disconnect the power cable.

the Drive Module" on page 3-4.

Replacing Autoloader Parts

Returning the Autoloader

Lock Transport

3-9

R e

p l

a c

i n

P a

r t s

Table of Contents