Bringing The Drive Online - HP C7745NB - SureStore DLT Tape Autoloader 1/9 Manual

3. Tighten the top and bottom thumbscrews by hand, securing the drive
4. Plug the ribbon connector into the back of the drive module (see
5. Gently fold the ribbon cable that is attached to the connector plate
6. Holding the connector plate in place, tighten the thumbscrews by

Bringing the Drive Online

1. To bring the new drive online, enter the
2. Select
NOTE You may need to use the host backup software to recognize the new drive
when bringing it online. If the software does not have the capability to
automatically detect the new drive, you may need to reboot the host.
3. Download new firmware. See Chapter 4, "Upgrading Firmware" for
Chapter 3
module into the autoloader.
Figure 3-1 on page 3-4).
into the back of the drive module.
hand.
menus.
Drive Repair
[Put drive online]
The autoloader will automatically run a self-test when the drive has
been brought online.
more information.
Removing and Installing Drive Modules
Administration
to bring the drive back online.
Replacing Autoloader Parts
then the
Online
3-7
R e
p l
a c
i n
g
P a
r t s