HP C7745NB - SureStore DLT Tape Autoloader 1/9 Manual page 25

The MAC address is unique to each remote management card and is used
NOTE
for identification. This address cannot be configured. To successfully use
BOOTP from the autoloader, you must first configure the BOOTP server
using the MAC address.
6. Enter the desired IP address.
7. Enter the
8. Enter the
9. Press
10. Enter the designated IP address into the web browser to launch the
Chapter 2
• If DHCP/BOOTP was not successful or if you do not want to use
DHCP/BOOTP, contact your system administrator to obtain an IP
address, subnet mask, and gateway address.
Use the key to change the number.
[+]
Use the key to move to the next number.
[->]
Use the key to move to the next address.
[Down]
subnet mask
gateway address
when complete to save the changes, or press
[OK]
the menu and not save the changes.
A message will display to confirm the changes you have entered or
alert you if the changes have not been saved.
browser.
Example 1 - All modes (Manual configuration, DHCP, or
BOOTP):
IP address = 15.28.33.12
http://15.28.33.12
Example 2 - With a DNS server present:
Device name = library1
http://library1
Your system administrator must add the device name you select to
the Domain Name Server (DNS).
using the same procedure.
.
Upgrading the Autoloader
Web Monitoring
to exit
[Quit]
2-7
U p
g r
a d
i n
g
t h
e
A u
t o
l o
a d
e r