Figure 3-5 Internal Packaging - HP C7745NB - SureStore DLT Tape Autoloader 1/9 Manual

To remove the autoloader from a rack, do the following:
1. Extend the rack's anti-tip foot.
2. Loosen the screws that secure the autoloader in place. The screws are
3. Using two people or an appropriately rated mechanical lift, remove
4. Place the autoloader on a solid surface to prepare it for packaging.
5. To remove the trim bracket and filler panel see "Removing the Trim
6. Re-install the internal packaging behind the autoloader front door to
7. Place the autoloader into the packaging received with your
Figure 3-5 Internal Packaging
Chapter 3
located in front of the trim bracket and filler panel on the front of the
autoloader.
the autoloader from the rack tray by sliding it out and supporting it
from the bottom.
Bracket and Filler Panel" on page 1-7.
prevent the magazine from moving (see Figure 3-5).
replacement autoloader or in the original packaging. If you need
packaging, contact your service representative to purchase the
packaging kit.
Replacing Autoloader Parts
Returning the Autoloader
3-11
R e
p l
a c
i n
g
P a
r t s