Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - DISCOVERY-DEPLOYMENT-RETIREMENT REFERENCE 10.3 30-03-2010 Deployment Manual page 44

3 In the Advertised Discovery Interval panel, modify the following settings as necessary:
Allow the system to check for advertised devices: Select this option to enable advertised
discovery. All ZENworks Servers perform the discovery. When a preagent receives a discovery
request, it responds to the ZENworks Server that initiated the request.
Days, Hours, Minutes: Specify how often you want to perform the advertised discovery.
4 In the Advertised Discovery Subnets panel, specify subnets for the advertised discovery. By
default, the ZENworks Server that performs the discovery scans on its local subnet only.
To specify a subnet:
4a To specify a subnet, fill in the following fields:
IP Address: Specify an IP address located within the subnet. Use the standard dotted-
decimal notation. For example, 123.45.167.100.
Optional CIDR Subnet Mask: Specify the subnet by using the standard CIDR (Classless
Inter-Domain Routing) notation. With CIDR, the dotted decimal portion of the IP address
(in the IP Address field) is interpreted as a 32-bit binary number that has been split into
four 8-bit bytes. You can use this field to enter the prefix length, which is the number of
shared initial bits, counting from the left side of the address. The prefix length can range
from 0 to 32, with 8, 16, 24, and 32 being commonly used numbers. For example,
123.45.167.100 with an optional CIDR subnet mask (or prefix length) of 24 matches
specifies the 123.45.167 subnet.
4b To add the subnet to the list, click Add.
4c (Optional) To add additional subnets, repeat
4d (Optional) To reorder the list, select a subnet, then click Move Up or Move Down.
The subnets are scanned in the order listed, from top to bottom.
5 Click OK.
44 ZENworks 10 Configuration Management Discovery, Deployment, and Retirement Reference
Step 4a and Step 4b.