Deploying The Inventory-Only Module; Downloading The Module From A Zenworks Server - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - DISCOVERY-DEPLOYMENT-RETIREMENT REFERENCE 10.3 30-03-2010 Deployment Manual

Deploying the Inventory-Only
1 2
Module
If a Windows device does not meet the requirements for deploying the Adaptive Agent, or if you
want to inventory a Windows, Linux, NetWare
Inventory-Only module. See
Management Installation Guide
Only module is supported.
The following sections provide instructions:
Section 12.1, "Downloading the Module from a ZENworks Server," on page 101
Section 12.2, "Installing on Linux/UNIX," on page 102
Section 12.3, "Installing on NetWare," on page 103
Section 12.4, "Installing on Windows," on page 103
Section 12.5, "Installing on Macintosh OS X," on page 103
12.1 Downloading the Module from a ZENworks
Server
1 On the target device, open a Web browser to the following address:
http://server/zenworks-setup
where server is the DNS name or IP address of a ZENworks
If you are downloading the NetWare module, open the Web browser on a device from which
you have file copy access to the NetWare server.
IMPORTANT: The Inventory-Only module uses the default port (80 or 443) and not the
customized port configured on the ZENworks Server.
2 In the left navigation pane, click Inventory Tools.
The Inventory-Only Module for each platform is listed on the page:
®
, or Macintosh OS X device, you can deploy the
"System Requirements" in the
for information about the platform versions on which the Inventory-
ZENworks 10 Configuration
®
Server.

Deploying the Inventory-Only Module

12
101