Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - COMMAND LINE UTILITIES REFERENCE 10.3 30-03-2010 Command Reference Manual page 99

ZENworks Diagnostic Center
3
® ®
Novell ZENworks 10 Configuration Management SP3 provides a new tool called as ZENworks
Diagnostic Center that helps you to verify the health of the Primary Servers and the Management
Zone before deploying a system update.
ZENworks Diagnostic Center (ZDC) performs a series of diagnostic tests on Primary Servers, and
determines the state of the Primary Servers and the Management zone. ZDC comprises of the
following verifiers:
ZENworks System Files Verifier: Verifies the existence and consistency of critical system
files that are required by ZENworks 10 Configuration Management.
ZENworks Database Schema Verifier: Validates the correctness of the schema (tables,
indexes, database procedures, etc) of the database used by ZENworks 10 Configuration
Management.
ZENworks Content Verifier: Validates the existence and consistency of the contents hosted
on the Primary Server that has ZDC installed and running.
Review the following sections:
Section 3.1, "Downloading and Extracting ZDC," on page 99
Section 3.2, "Running ZDC," on page 100
3.1 Downloading and Extracting ZDC
You have to download and extract ZDC on the Primary Server on which you want to run the tool.
1 Open a Web browser to the following address:
http://server/zenworks-setup
where server is the DNS name or IP address of a ZENworks Server.
ZENworks Diagnostic Center
3
99