Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - COMMAND LINE UTILITIES REFERENCE 10.3 30-03-2010 Command Reference Manual page 95

zac reg -k key1 -u administrator -p novell https://
zenserver.novell.com:8080
The port number is required only if the ZENworks Server is not using the standard HTTP port
(80). If a username and password are not supplied, you are prompted for them.
reregister (rereg)[-u <username> -p <password>] <new guid>
Registers a device in the current zone and assigns it the GUID of an existing device object. The
currently associated device object is deleted.
For example, if you image a device after replacing the hard drive, the device might get a new
GUID. However, by using the reregister command, you can assign the same GUID that it had
before you replaced the hard drive.
Examples:
To reregister, specify a username and password:
zac reregister -u myuser -p mypassword eaa6a76814d650439c648d597280d5d4
To reregister and be prompted for a username and password:
zac reregister eaa6a76814d650439c648d597280d5d4
unregister (unr) [-f] [-u <username> -p <password>]
Removes the device's registration from the Management Zone.
Example:
zac unr -u administrator -p novell
The , , and
-f -u -p
prompted to enter a username and password. The
and forces the device to be unregistered locally; this option is necessary only if the device
object has already been deleted from the ZENworks database or if the device cannot connect to
the database.
Satellite Role Commands
satellite-cachecfg (satcfg)
Reads Satellite roles from cache.
Example:
zac satcfg
satellite-clearcache (satcc)
Clears Satellite configuration information from cache.
Example:
zac satcc
satellite-refreshcfg (satrc)
Refreshes Satellite roles.
Example:
zac satrc
parameters are optional. If you don't use the and
-u -p
parameter ignores the ZENworks database
-f
Command Line Utilities for Linux Satellites
parameters, you are
95