Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - COMMAND LINE UTILITIES REFERENCE 10.3 30-03-2010 Command Reference Manual page 86

Registration Commands
add-reg-key (ark) <registration key>
Registers the device by using the specified key. Registration with keys is additive. If the device
has previously been registered with a key and you register it with a new key, the device receives
all group assignments associated with both keys.
Example:
zac ark key12
get-settings (gs) <registration key>
Lists the settings associated with the specified registration key.
Example:
zac gs key1
You can also use the
more information, see
register (reg) [-g] [-k <key>] [-u <username> -p <password] <ZENworks Server
address:port>
Registers the device in a Management Zone.
You can use the following options:
g - Lets you create a new device object with a new GUID and password for the device if you
have multiple devices with the same GUID. When you register a device by using this switch,
all the associations (policies and bundles) assigned to the original device object are removed.
You cannot use this option to create a new GUID for a Primary Server or a Satellite device.
The local user must have Local Administrator rights to use this option.
k - Lets you register the device using the specified registration key.
p - Lets you specify the Management Zone administrator's password.
u - Lets you specify the Management Zone administrator's username.
Examples:
zac reg -k key1 https://123.456.78.90
zac reg -k key1 -u administrator -p novell https://
zenserver.novell.com:8080
The port number is required only if the ZENworks Server is not using the standard HTTP port
(80). If a username and password are not supplied, you are prompted for them.
reregister (rereg)[-u <username> -p <password>] <new guid>
Registers a device in the current zone and assigns it the GUID of an existing device object. The
currently associated device object is deleted.
For example, if you image a device after replacing the hard drive, the device might get a new
GUID. However, by using the reregister command, you can assign the device's GUID that it
had before you replaced the hard drive.
Examples:
To reregister, specify a username and password:
zac reregister -u myuser -p mypassword eaa6a76814d650439c648d597280d5d4
86 ZENworks 10 Configuration Management Command Line Utilities Reference
command to list settings using various keys. For
get-settings (gs)
get-settings (gs) <key>
in the Status Commands section.