Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - COMMAND LINE UTILITIES REFERENCE 10.3 30-03-2010 Command Reference Manual page 29

[-f|--folder=folder name including path of the dynamic group folder] - Dynamic group folder's
name, including its full path.
[-a|--all] - Refresh all existing dynamic groups.
Hotlist Command
This command is used to view the list of devices that have unacknowledged warnings or errors. The
command begin with
Hotlist
All of the commands below accept the option flags listed in the
they accept individual options as listed with each command.
hotlist-view (hlv) [options]
Lists devices that have unacknowledged warnings or errors.
Accepts the following options:
-c, --count - Displays only the count of the hotlist items.
-t, --type=[error type] - Filters on the error type of hotlist items. Valid values are
,
Noncompliant Critical
-o, --operator=[comparison operator] - If specified, this operator is used in error-count-based
filtering. Valid values are >, >=, =, <, and <=. Enclose the operators in double quotation
marks so that > and < are not considered by the system as redirection operators.
-e, --errorcount=[erorr count] - Filter by the count of the error type specified. If the comparison
operator is not specified , the
taken as the sum of noncompliant, critical and warning errors.
-s, --scrollsize=[scrollsize] - Number of results to be displayed at a time.
Warning or errors can be acknowledged by using the
When all warnings or errors for a device are acknowledged the messages no longer appear on
the hotlist.
Imaging Commands
These commands are used to perform Imaging operations. Imaging commands begin with
in the long form, or with the letter
imaging-apply-assigned-imaging-bundle (iaaib) (Device type) (Device name>
<Device name> ... <Device name>)
Applies the most effective Imaging bundle.
Accepts the following options:
(Device type) - Valid values are
(Device name) - Name of the server or workstation object.
For example, to apply the assigned Imaging bundle to a server with the name server1, run the
following command:
zman iaaib server server1
If the device object is located within a folder, use the following the command:
iaaib (Device type) (folder/path of device)/(Device name)
in the long form, or with the letter
hotlist-
, and .
Warning
is used by default. If error type is not specified, the count is
>=
in the short form.
i
and
server workstation
in the short form.
hl
Global Options section. In addition,
messages-acknowledge
.
ZENworks Command Line Utilities
command.
imaging-
29