Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - COMMAND LINE UTILITIES REFERENCE 10.3 30-03-2010 Command Reference Manual page 104

Unable to save the report on SLES 10 SP1 by using the zman rpgn command
The Imaging role added to a Satellite by using the zman ssaimg command is not
immediately applied to the server
Explanation: If you configure the Imaging role by the using the
The zman commands do not work for non-root users on a ZENworks Linux server
Explanation: If a non-
104 ZENworks 10 Configuration Management Command Line Utilities Reference
Source: ZENworks 10 Configuration Management; zman.
Action: None.
Source: ZENworks 10 Configuration Management; zman.
the role is immediately added to the device. If the role is not immediately
added, it is added only during the next device refresh schedule.
Action: If you want to immediately apply the role to the device, you must manually
refresh the device in one of the following ways:
At the command prompt, run the
command. If the managed device is a server, run the
refresh|srf
On the managed device, right-click the
Source: ZENworks 10 Configuration Management; zman.
user executes the zman commands on a ZENworks Linux server,
root
the following error message is displayed:
You do not have sufficient privileges to run zman commands. As
a non-root user in Linux, you should be part of the zmanusers
group to run zman commands
Action: Add the non-
root
commands.
1 Log in to the ZENworks server as
2 At the server console prompt:
If the user already exists on the Linux device, execute the following
command:
groupmod -A non-rootusername zmanusers
If the user does not exist on the Linux device, execute the following
command:
useradd -G zmanusers non-rootusername
3 Log in to the ZENworks server as a non-
zman workstation-refresh|wrf
command.
.
user to the zmanusers group before executing the zman
root
command,
zman ssaimg
zman server-
icon, then click Refresh.
.
user.
root