Novell ACCESS MANAGER 3.1 SP1 - GATEWAY GUIDE Manual page 28

You must create the policy before you can assign it to a resource (see
in the Novell Access Manager 3.1 SP1 Policy Management
protected resource:
1 In the Administration Console, click Devices > Access Gateways > Edit > [Reverse Proxy
Name] > [Name of Proxy Service] > Protected Resources > [Name of Protected Resource].
2 Examine the entries in the URL Path List.
Ideally, the URL to which you are assigning a Form Fill policy should be a single HTML page
or a few HTML pages. If at all possible, it should not be a URL that ends in a wildcard (for
example, an asterisk) and therefore matches many pages.
IMPORTANT: When the URL ends in a wildcard, the Access Gateway must search each page
that matches the URL and check to see if it contains the form. This adds extra processing
overhead for all the pages that match the URL, but do not contain the form. For more
information on the performance problems this can cause, see
in the
3 (Conditional) If the URL is not specific, click the name of the path and modify it.
4 Click Form Fill.
The Form Fill Policy List contains all the Form Fill policies that have been created on this
Administration Console for the selected policy container.
5 Select one of the following:
To enable an existing policy, select the policy, then click Enable. Only the policies that are
enabled are applied to this resource. Continue with
To disable an existing policy, select the policy, then click Disable. Continue with
To edit an existing policy, click the name of the policy. Remember that policies can be
assigned to multiple protected resources. If you modify the policy, you are also affecting
how this policy protects those resources. For configuration information, see
Form Fill
When you have finished the policy modifications, continue with
To create a new policy, click Manage Policies. On the Policies page, click New, specify a
display name, select Access Gateway: Form Fill as the type, then click OK. For
configuration information, see
Manager 3.1 SP1 Policy Management
When you have created your new policy, continue with
6 To enable the policy you just created, select the policy, then click Enable.
28 Novell Access Manager 3.1 SP1 Access Gateway Guide
Novell Access Manager 3.1 SP1 Policy Management
Policies" in the Novell Access Manager 3.1 SP1 Policy Management
Guide). To assign a Form Fill policy to a
"Creating a Form Matching
Guide.
Step
"Creating Form Fill Policies" in the
Guide.
"Creating Form Fill Policies"
7.
"Creating
Guide.
Step 7.
Novell Access
Step 6.
Rule"
Step 7.