Access Gateway Maintenance; Gateway Appliance Logs; Configuring Log Levels - Novell ACCESS MANAGER 3.1 SP1 - GATEWAY GUIDE Manual

Access Gateway Maintenance

4
Section 4.1, "Gateway Appliance Logs," on page 107
Section 4.2, "Configuring Proxy Service Logging," on page 110
Section 4.3, "Monitoring Access Gateway Statistics," on page 118
Section 4.4, "Monitoring Access Gateway Alerts," on page 128
Section 4.5, "Enabling Access Gateway Audit Events," on page 133
Section 4.6, "Managing Server Health," on page 134
Section 4.7, "Viewing the Command Status of the Access Gateway," on page 139

4.1 Gateway Appliance Logs

This section contains the following information about the Access Gateway Appliance logs:
Section 4.1.1, "Configuring Log Levels," on page 107
Section 4.1.2, "Interpreting Log Messages," on page 108
Section 4.1.3, "Configuring Logging of SOAP Messages and HTTP Headers," on page 109

4.1.1 Configuring Log Levels

You can use the following procedure to set the level of information logged to the
in the directory.
/var/log
1 At the command prompt, enter the following command:
nash
2 At the shell prompt, enter the following command:
nash
configure .current
3 To change the log level, enter the following command:
log-conf log-level <log level>
Replace <log level> with the new log level that you want to set.
Level
LOG_EMERG
LOG_ALERT
LOG_CRIT
LOG_ERR
LOG_WARNING
LOG_NOTICE
Description
Sends only messages that render the system unusable, if they are not
resolved.
Sends only messages that require immediate action.
Sends only messages about critical situations.
Sends warning messages about recoverable errors.
Sends warning messages.
Sends information about the status of a service to the service
configuration logs.
file
ics_dyn.log
Access Gateway Maintenance
4
107