Novell ACCESS MANAGER 3.1 SP1 - GATEWAY GUIDE Manual page 132

7b Click OK.
8 To enable syslog alerts click New in the Send to Syslog section, specify a name for the Syslog
profile, then click OK.
8a Configure the following syslog details:
8b Click OK.
9 To enable an alert action profile, select the action profile, click Enable, then click OK.
The action to send the alerts to a log file, to email addresses, or to a syslog file is not performed
until the action profile is enabled.
10 On the Alert Profiles page, verify that the Alert Profile you have created is enabled.
11 To save your modifications, click OK twice.
12 On the Access Gateways page, click Update.
Access Gateway Cluster Alerts
To view information about current alerts for all members of a cluster:
1 In the Administration Console, click Devices > Access Gateways > [Name of Cluster] > Alerts.
2 Analyze the data displayed in the table.
Column
Server Name
Severe
Warning
Information
132 Novell Access Manager 3.1 SP1 Access Gateway Guide
Mail Exchange Servers: To add a mail server, click New, specify the IP address or
the DNS name of the mail exchange server, then click OK. You can add multiple mail
exchange servers. To delete a server, select the server, click Delete, then click OK.
Facility Name: Specify a facility name for the Syslog server. It can be any name
from local0 to local7. If you specify local0 as your facility name, the alerts are stored
at
\var\logs\ics_dyn.log
normal logging information. Therefore, it is not recommended to specify local0 as
your facility name.
Description
Lists the name of the Access Gateway that sent the alert. To view
additional information about the alerts for a specific Access Gateway,
click the name of an Access Gateway.
Lists the number of critical alerts that have been sent and not
acknowledged.
Lists the number of warning alerts that have been sent and not
acknowledged.
Lists the number of informational alerts that have been sent and not
acknowledged.
. The Access Gateway Appliance uses local0 for