CARLO GAVAZZI G3800 X015 - CONFIGURATION SOFTWARE User Manual page 45

G 3800 X015 Configuration Software G 3800 X015 Configuration Software G 3800 X015 Configuration Software
Manual
armouring:
Door lock
armouring:
Code lock
armouring:
Alarm siren:
Alarm signal:
© 2002 Carlo Gavazzi Industri A/S. All rights reserved
This object makes it possible to include a push button to enable
and reset the alarm.
The object only enables the alarm contacts for which no or a deacti-
vated disable address has been entered.
Manual armouring thus partly enables alarms.
Upon activation of manual armouring, the armouring delay begins
to run. During this time, the channel generator ignores activated
alarm contacts.
If subsequently an enabled alarm contact is activated, this channel
begins to flash and triggers off an alarm through the siren after
elapse of the de-armouring delay.
To acknowledge the alarm, press the manual armouring key once.
To restart the alarm system, press twice.
This object makes it possible to include a switch to activate the
alarm system. The function is similar to that of the manual armour-
ing, only in door lock armouring the disable addresses entered at
the alarm contacts are ignored. This means that the switch per-
forms total enabling.
Upon activation of the switch, the armouring delay begins to run.
During this time, the channel generator ignores activated alarm
contacts.
If subsequently an alarm contact is activated, this channel (like
manual armouring) begins to flash and triggers off an alarm through
the siren after elapse of the de-armouring delay.
The alarm is acknowledged by switching off the door-lock armour-
ing. The system becomes alert by renewed switching on.
This object can be used as an alternative to door-lock armouring.
The mode of operation is identical, since this object also performs
total enabling of all - also disabled - alarm contacts.
The object awaits an impulse from the code lock to make the alarm
system alert. An additional impulse is needed in order to acknow-
ledge an occuring alarm (see manual armouring).
The alarm siren indicates that an alarm has occured. The channel
configured for this object can be used to output the alarm on differ-
ent output modules. It usually activates a relay output through
which a siren is switched.
The configuration also allows the alarm output to flash
and makes it possible to determine additional channels which also
flash.
When an alarm occurs, a channel configured with this object is
activated for 10 s and can thereby be used to activate a telephone
modem or a GSM modem.
October 2002 October 2002 October 2002
45