CARLO GAVAZZI G3800 X015 - CONFIGURATION SOFTWARE User Manual page 35

G 3800 X015 Configuration Software G 3800 X015 Configuration Software G 3800 X015 Configuration Software
Lamp test:
Alarm siren:
Parameters:
Parameter
Operation mode
Passive detector
Disable address
On-delay
Active detector
Disable address
© 2002 Carlo Gavazzi Industri A/S. All rights reserved
If a contact is activated during resetting, the system triggers off a new alarm
When this object is configured, the operation mode "Standard" is automatically
selected.
This object makes it possible to test the function of lamps indicating the status of
the alarm contacts. All alarm channels are activated upon actuation of the lamp
test button.
The alarm siren indicates the occurence of an alarm. The channel configured for
this object can be used for alarm output on a random number of output modules.
It usually activates a relay output switching a siren.
Description
Standard:
This setting means that activation of the alarm system takes place upon prior
release by the reset button. This entails that the object "Reset" must be config-
ured.
Auto reset:
With this setting, the system activates itself automatically upon acknowledge-
ment, when all passive and active detectors are in their "normal" position (in
which they do not trigger off alarms)
Note: Operation mode can be selected for any object of the ISA alarm - but
applies to the entire system. If the object "Reset" is selected to include a reset
button, the system assumes that the operation mode "Standard" is to be select-
ed. Simultaneously, the option operation mode is deactivated and can only be re-
activated by unclicking the object "Reset".
If "Auto reset" is selected, the system prevents configuration of the "Reset"
object.
Enter an address (A1..P8) or a flag (W1..Z8) whose activation ("1"-signal) will leave
out the Passive detector function of the monitoring system whereby it cannot
trigger off any further alarms.
Enter a time value in seconds (0..255) for which the alarm signal is delayed upon
activation of the alarm contact.
Enter an address (A1..P8) or a flag (W1..Z8) whose activation ("1"-signal) will leave
out the Passive detector function of the monitoring system whereby it cannot
trigger off any further alarms.
October 2002 October 2002 October 2002
35