The Intruder Alarm - CARLO GAVAZZI G3800 X015 - CONFIGURATION SOFTWARE User Manual

G 3800 X015 Configuration Software G 3800 X015 Configuration Software G 3800 X015 Configuration Software

2.4.5. The Intruder Alarm

Description
The purpose of the Intruder Alarm is an alarm system consisting of various contacts integrated as Passive or
Active detectors. The wiring makes it possible to replace conventional intruder alarm systems.
Apart from the contacts represented by their own objects (Passive and Active dectector), it is also possible to
include toggle switch functions and motion detectors which have already been configured. This is done
directly when setting the parameters for these objects.
A system which is enabled will then start an alarm when one or several alarm contacts have been activated.
The channel for the activated alarm channels (as alarm source indication) as well as the alarm output start to
flash after the set time delay. By subsequent activation of the Manual armouring, the Door-lock armouring or
Code lock armouring, the Master Generator switches the channel out of the system and switches the alarm
output off.
If an alarm is not acknowledged before elapse of the alarm signal delay, the system automatically becomes
alert again.
Note: Configuration of the objects "Manual armouring", "Door-lock armouring" or "Code lock armouring" is
absolutely necessary to ensure correct function.
It is not necessary to use the objects "Manual armouring" or "Code lock armouring", but it is possible to have
an operation mode in addition to or in stead of the "Manual armouring". By use of two objects, an alarm must
necessarily be acknowledged with the object which is also used to alert the system.
The status of the alarm detectors can be shown in a simple way on a panel. All that is needed for this purpose
is that the output channels are coded to the addresses of the alarm contacts.
The object "Alarm signal" makes it possible to control a telephone or GSM modem because of the short mes-
sage on this channel.
For alarm purposes the object Common Siren can also be used. Details can be found in the chapter describ-
ing The alarm siren/Common siren.
The various Intruder alarm objects are selected under "Channel function":
Passive detector:
Active detector:
Toggle switch function:
Motion detector:
44
• Function: Intruder alarm system including Passive/Active detector contacts, Toggle switch
functions, Motion detectors, Manual and Door-lock Armouring, Code lock Armouring, Alarm
siren and Alarm signal
• Application: Wiring of intruder detector contacts to an alarm system
• Select with mouse ("Intruder alarm") or short-cut key "I"
This object makes it possible to control windows, doors, etc. with Passive de-
tector. If the contact is activated and a "1"-Signal consequently
transmitted on the Dupline bus, an alarm is started.
This object makes it possible to control windows, doors, etc. with Active de-
tector. When the contact is activated and a "0"-Signal consequently
transmitted on the Dupline bus, an alarm is started.
"Use in Intruder alarm". See the chapter describing the Toggle Switch function
The motion detector can also be integrated in the intruder alarm. See the
chapter describing the Motion detector.
© 2002 Carlo Gavazzi Industri A/S. All rights reserved
October 2002 October 2002 October 2002